Design of an Energy Efficient IOT Enabled Smart System Based On DALI Network Over MQTT Protocol

Automation of dry-wet dust collection to support Swachh Bharat Abhiyaan and monitoring over Internet of Things (IOT)

 

Technical Specifications:

 

Title of the project                  :         Automation of dry-wet dust collection to support

Swachh Bharat Abhiyaan and monitoring over

Internet of Things (IOT)

Domain                                   :           Embedded Systems Design

Power Supply                          :           +9V, 500mA Regulated Power Supply

Microcontroller                       :           8051 controller

Software                                 :           Embedded C, Keil, Proload

Display                                    :           16×2 LCD Display

Communication device           :           RF Module (Tx, Rx )

DC Motor                               :           2

Crystal                                     :           11.0592MHz

Applications                            :           Metros, Rural Applications, Home, Industries etc.,

 

  

Abstract:

 

Swachh Bharat Abhiyan (English: Clean India Mission and abbreviated as SBA or SBM for “Swachh Bharat Mission”) is a national campaign by the Government of India, covering 4,041 statutory cities and towns, to clean the streets, roads and infrastructure of the country.

The aim of the mission is to cover all the rural and urban areas of the country to present this country as an ideal country before the world. With the proliferation of Internet of Things (IoT) devices such as smartphones, sensors, cameras. It is possible to collect massive amount of garbage.

This project is designed for the effective dry and wet dirt collection using Embedded System. The main motto of this application collecting of dry and wet waste separately into the dumping vehicles. We will place a conveyor belt on which the dry waste collected dust bins are placed left side and wet waste collected bins on right side. The system gets the input through the dust collecting boy through switches.

The switches send the signal to the Micro controller using RF technology and that makes  the H-bridge to rotate the conveyor belt. When the belt is rotating the dust bins are emptied to the dumping vehicle in sequence. Here we are using AT89S52 as our controller. Here IoT is interfaced to make the information available in the internet about the motor movement.

 

This project uses regulated 5V, 500mA power supply. 7805 three terminal voltage regulator is used for voltage regulation. Bridge type full wave rectifier is used to rectify the ac out put of secondary of 230/12V step down transformer.

 


Comments are closed.